







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Fence Installation for Fremont Homeowners
Fremont sits in a wind corridor between the bay and the hills, and fences here take a beating that fences in San Jose or Livermore don’t always see. We regularly find winter storm damage on the western exposures in Niles and Mission San Jose, and dry-rot at the base of older redwood boards in Centerville, where sprinkler overspray keeps the soil damp year-round. Our technicians have up to 19 years of experience installing and repairing fences across Alameda County, and every job comes with a flat written price before we pick up a tool, backed by our 365-Day Done Right Promise. Call (866) 797-6171 to schedule a free estimate.
Whether you’re replacing a leaning board fence in Irvington or setting a new vinyl privacy run along a lot line in Ardenwood, you’ll get a written scope, a written warranty, and a documented photo record of what we found and what we built.
What Our Fence Installation Service Includes
We install, repair, and replace every common residential fence type in Fremont. Here’s what each one means for your property and what we actually do on the ground.
Wood Fence
Wood is the standard fence in older Fremont neighborhoods, and it’s what most homeowners picture when they think “fence.” You need a wood fence when the existing boards are warped, split, or pulling away from the rails, or when you’re starting fresh on a new lot. We set posts in concrete footings sized to the local soil and wind load, use galvanized fasteners so the hardware doesn’t rust out before the wood does, and brace the runs at corners and gates, where fences fail first.

Chain Link Fence
Chain link is the practical choice for side yards, dog runs, and rental properties where durability matters more than looks. It’s the right call when you need a secure boundary fast and want minimal maintenance. We set chain link with tension bands and a top rail that won’t sag, and we check property-line setbacks before laying out the run so you don’t end up in a dispute with a neighbor.

Vinyl Fence
Vinyl is the fence that needs the least attention after installation, which is why we see it going up in newer developments around Warm Springs. You want vinyl when you’re tired of staining and don’t want to think about rot. We use vinyl systems with reinforced bottom rails and aluminum inserts in the posts, because the cheap hollow-post kits buckle in summer heat.

Aluminum Fence
Aluminum gives you a clean, open look at a fraction of the weight and cost of iron, and it doesn’t rust. It’s the right pick for front-yard boundaries, pool surrounds, and anywhere you want visibility without a solid wall. We set aluminum panels plumb and level, and we powder-coat or factory-finish the components so the color holds through Fremont’s dry summers.
Iron Fence
Wrought iron and ornamental iron are the premium choice for a statement front boundary, and they last decades when they’re installed right. You’ll want iron when curb appeal matters and you’re planning to stay. We set iron posts in deep footings and prime and coat every weld and cut end, which is where cheap iron fences start rusting within two years.
Fence Repair
Not every fence needs replacing. A lot of what we see in Fremont is one or two failed posts, a gate that’s sagged out of square, or a section knocked down by wind or a car. When the rest of the fence is sound, we repair the failed section, reset or sister the post, and rehang the gate, and the documented photo record shows you exactly what we replaced and why.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Fence Installation
Fence components fail in predictable places, and knowing the materials matters as much as knowing the trade. We work with Oldcastle hardscape and masonry products where a fence meets a retaining wall or paver border, and we understand how those edges need to be detailed so the fence footing doesn’t undermine the wall. We also work with Quikrete and Sakrete concrete mixes for post footings, and we know the difference in set time and strength between a fast-setting mix and a standard mix, which decides whether a post is stable by the end of the day or needs to cure overnight before the panels go up.
Whether you have Oldcastle pavers running up to your fence line, a Quikrete footing that’s already poured, or any other make of material, we can help. We’ll tell you what we found, what we’ll do, and what it costs before anything starts.
Signs You Need Fence Installation Right Now
- Posts leaning or pulling out of the ground. A leaning post usually means the footing has failed or the soil has shifted, and once one post goes, the panels on either side carry load they weren’t built for. Left alone, a single failed post becomes a full section replacement.
- Boards that are soft, splitting, or falling off the rails. Dry-rot spreads through a fence faster than most people expect, especially at the base where moisture collects. If you can push a screwdriver into the wood, the board is past saving and the run needs replacement.
- A gate that drags, sags, or won’t latch. A sagging gate is the most common fence failure we see, and it’s usually a hinge or post problem rather than the gate itself. Catching it early keeps it a repair instead of a rebuild.
- Rust bleeding through iron or steel components. Rust on a weld or a cut end means the coating has failed and moisture is getting into the metal. Iron fences in Fremont rust fastest at the welds and the base plate, and catching it means re-coating instead of replacing.
- Fence panels that move in the wind. A fence that shifts or rattles in a gust is under-built or the posts aren’t deep enough for the local soil. In Fremont’s wind corridors, a loose fence becomes a downed fence after the first big storm.
Our Fence Installation Process – Step by Step
- 1
On-site walkthrough and written scope. We walk the property line with you, measure the run, check existing posts and footings, and confirm where the boundary actually sits. You get a written scope and a flat written price before any work starts. If you have a competitor’s estimate, we’ll review it line by line at no charge as a free second opinion.
- 2
Material and layout confirmation. We confirm the material, height, color, and gate locations against your property survey or plat. Any change to the scope is documented in a change order, and no work proceeds on a change until that change order is signed.
- 3
Post setting and footings. We dig and set posts in concrete footings sized to the fence height and local soil conditions, and we brace the run while it cures. This is the part that decides whether the fence is still straight in ten years, and we don’t cut corners on it.
- 4
Panel, rail, and gate installation. We hang panels, set rails, and install gates so they swing clean and latch without dragging. Every gate gets a check for square and swing clearance before we move on.
- 5
Walkthrough and documented photo record. We walk the finished fence with you, show you what was installed, and hand over a documented photo record of the work plus the written warranty. Under the 365-Day Done Right Promise, if it isn’t done right, we make it right.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fence Installation Cost in Fremont?

Fence installation in Fremont typically runs $3,500 – $9,000 for a standard residential run, depending on material and length. A typical wood fence in Fremont runs $3,500 – $9,000; vinyl fence installation runs $3,500 – $9,000; and aluminum fence installation runs $4,000 – $10,000. Those ranges are calibrated to what we actually see across Fremont’s neighborhoods, not pulled from a national average.
What affects the price: the material you choose, the linear footage of the run, the number of gates, the condition of the soil and whether old footings need to be removed, and whether the fence follows a slope or a flat grade. A sloped run along the hills in Mission San Jose costs more to set than a flat run in Ardenwood because every post has to be individually set to grade. Fence repair is quoted separately and is almost always cheaper than replacement when the posts are sound.
To avoid overpaying, get at least two written estimates, ask whether old fence removal is included, and confirm the footing depth and post spacing in writing. Our free estimate includes a written scope, a flat price, and a written warranty, so you’re comparing the same thing when you look at the numbers. Call (866) 797-6171 for an exact quote on your Fremont fence.
Fence Installation Near Fremont – Our Service Area
We install and repair fences throughout Fremont and the surrounding East Bay and South Bay cities, including Fence Installation in Milpitas, Fence Installation in Alum Rock, Pleasanton, San Jose, Dublin, Livermore, San Ramon, Blackhawk, Morgan Hill, Clayton, and Brentwood. Most Fremont jobs are scheduled within a few days of the written estimate, and we can usually get a crew out the same week for repair work. See our Fence Installation in Fremont page for the full local detail, or return to the home page to see all seven trades we install.
Serving Fremont, CA – Our Local Coverage Area
We serve Fremont and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Fence Installation in Fremont

Fence installation is the process of setting posts, hanging panels or rails, and mounting gates to create a boundary, privacy screen, or security line on your property. It covers material selection, footing depth, property-line layout, and gate hardware, all of which decide whether the fence lasts. In Fremont we install wood, chain link, vinyl, aluminum, and iron fences, plus repair work on existing fences.
A standard residential fence run in Fremont usually takes one to three days, depending on length, material, and the number of gates. A short repair can be done in a few hours; a long sloped run with several gates takes longer because each post has to be set to grade. We give you a written timeline with the estimate so you know what to expect.
Fence installation in Fremont typically runs $3,500 – $9,000 for a standard residential run. Vinyl and wood tend to land in the same $3,500 – $9,000 range, while aluminum runs $4,000 – $10,000; iron costs more. Call (866) 797-6171 for an exact quote, and estimates are free.
Yes. We work with Oldcastle hardscape and masonry products and with Quikrete and Sakrete concrete mixes for footings, and we know how each one behaves once it’s in the ground. Whether you have Oldcastle pavers meeting your fence line, a Quikrete footing already poured, or any other make, we can help. We’ll tell you what we found and what it will cost before work starts.
Yes, we handle urgent fence repair in Fremont, including storm-damaged runs, downed sections, and gates that won’t close. A live person answers our phones around the clock, so you can reach us when a fence goes down at night or on a weekend. We prioritize safety and security issues first.
Every fence we install comes with a written warranty and the 365-Day Done Right Promise: if it isn’t done right, we make it right. The warranty is printed and handed over with the documented photo record of the work, not buried in fine print. Call (866) 797-6171 to see a sample warranty with your free estimate.
Clear personal items and vegetation away from the fence line, and make sure we have clear access to the property line and any gate locations. If you have a property survey or plat, have it ready so we can confirm the boundary before we dig. We handle the rest, including old fence removal when it’s included in the written scope.
Schedule Your Fence Installation Service in Fremont Today
If your fence is leaning, rotting, or you’re ready to install a new one, call (866) 797-6171 to schedule your free estimate. You’ll get a flat written price before any work starts, a written scope and warranty, and a documented photo record when the crew leaves. No obligation, no pressure, and if you have a competitor’s quote, we’ll review it line by line at no charge.
Written by the team at Rowan Construction Group.












